This Swiss-style miter vise, made of hardened steel, is used for holding wire and sheet up to 6mm (1/4") thick and 34mm (1-3/8") wide at both 45 degrees and 90 degrees. Cut and file consistent, 90 and 45 degree angles in all metals to ensure clean fitting solder joints. V-grooves self-center around wire or tubing for increased accuracy. Swiss-style, made of hardened steel. A stop bar is included to perform consistent cuts repeatedly. Made of high-grade hardened steel (60 HRC).
.- Material: High-grade hardened steel (60 HRC).
.- Used for holding wire and sheet
.- Capacity : up to 6mm (1/4") thick and 34mm (1-3/8") wide at both 45 degrees and 90 degrees.
.- For 90 and 45 degree angles.
JIG VISE MITER TUBE CUTTER FILING BLOCK JEWELERS TOOL CHENIER TUBE SAW CUTTING
JIG VISE MITER - TUBE CUTTER - FILING BLOCK
Jig is a miniature miter vise used by Jewelers to cut and file tubes, wire, rods and flat strip of metals. Tool holds stock material up to 1/2" thick. Tool can be used to saw cut or file parts perfectly at 90o and 45o angles.
Miter is made of hardened steel (62-65RC) long lasting and durable. The Jig is a precise 3 part steel block that interlock to each other, and hold parts true and permit perfect operation on the edges of the piece/s.
Miter Jig has an adjustable stop that can be fixed to the desired length with hex screw (key Included), for repetitive cutting of the same lengths.